Requirements and markings for fastening devices
We would like to refer to regulation No. 305/2011 of the European Parliament and of the Council, which states that all construction products covered by a harmonised European Standard (hEN) or a European Technical Assessment (ETA) must have a CE marking.
Janere has a wide selection of fastening devices with CE markings that meet the requirements outlined in such standards. Products with CE markings have been tested before launching them on the market and their quality has been guaranteed – this is further assured by the Declaration of Performance issued by the manufacturer.
Before purchasing fastening devices, please make sure that the product you have chosen meets the requirements set by the engineer. We would also like to draw your attention to the fact that not all products are required to have the CE marking. This obligation is only valid for products that can be used as described in hEN or ETA.
Today, harmonised product standards apply to the following fastening devices used in construction:
EN 14399 High-strength structural bolting assemblies for preloading. EN 14566 Mechanical fasteners for gypsum plasterboard systems. EN 14592 Timber structures. Dowel-type fasteners. Requirements. EN 15048 Non-preloaded structural bolting assemblies.
OÜ Janere
Address: Põldmäe tee 14, Vatsla küla, Saue vald, 76915 Estonia Reg. no.: 10001584 VAT no: EE100248665 Phone: +372 658 0300 Fax: +372 607 7762 E-mail: janere@janere.ee